reset airbag modulw honda fit 2016 with obd2

Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).Click on the photo below right to expand and you can see the pin numbers marked in the plastic. I used a paper clip, but any stiff (solid) light gauge wire will do. Short pins 4 and 9 on the OBD connector located under the dash on the driver side.Turn the Ignition switch OFF and take the key out. After fooling around with advice from various sources and checking fuses and disconnecting the battery negative cable for several hours with no success, I found the following procedure which worked perfectly:

Of course one repair option is to take the vehicle to a dealer to clear/reset the fault, but that is going to cost $50-$100 or more based on various reports I have seen. This procedure probably applies to many models and model years of Honda vehicles. The procedure below has worked for us to clear/reset the “fault” generated by the low battery voltage condition. In this instance, clearly the “fault” is some anomaly caused by the low battery voltage. However, even after boosting the battery (we carry a portable booster just for such occasions) and getting the vehicle started, the ABS and VSA dash lights remain illuminated indicating a fault. Are one or both of the ABS and/or VSA dash lights on your Honda as shown below staying on all the time? Have you recently had a dead or weak battery and couldn’t start the car? Read on, this may be just the solution you are looking for to clear those fault codes and save you having to go to a dealer and pay a labor charge.Ī couple of times our 2013 Honda Odyssey battery has become discharged enough so the car won’t start (low voltage), usually due to our umbilical cable having some sort of issue while towing it behind our motorhome and not charging the battery.

Reset airbag modulw honda fit 2016 with obd2